General Troubleshooting
Troubleshooting
Problem Possible cause Fault correction
Motor will not start Collection box not tted
correctly
Push the collection box
rmly to its correct position,
and place the safety switch
on the box to the ON
position.
Overload protection To switch back on, start by
turning the operating mode
selection switch (A9) to the
“OFF” position.
Press the reset switch (A7).
Switch the device back on.
No mains power supply Check the socket, cable, lead
and plug for damage, and if
necessary, have any damage
repaired by qualied repair
personnel.
Garden waste is not drawn in Cylinder running in reverse Change rotational direction
using the switch
Shredding material is too soft Insert wood or shred dried
branches
Shredder blade remains
jammed
Clear the jam (See section on
operation)
Shredding material comes out
in chains
Pressure plate is incorrectly
adjusted
Readjust the pressure plate
(See section on adjusting the
pressure plate)
To Next Page
Loading...