Quantum DXi4700 - Chapter 3: Remote Management; DXi4700 Remote Management Overview

Initial Configuration
Quantum DXi4700 Installation Guide 56
Figure 43: Internet Protocol Version 4 (TCP/IPv4) Properties Window
d. Select Use the following IP address and then enter the following information:
Caution: Before changing the IP address information, write down the original settings. This
will be used later to reset the network configuration.
l IP address - 10.1.1.2
l Subnet mask - 255.255.0.0
e. Click OK, and then click Close.
f. Wait at least two minutes for the computer to set the IP addresses on the local computer.
4. On the computer, open a supported Web browser, type 10.1.1.1 in the Address box, and press