Quantum DXi4700 - Page 89

DAE/Veeam Memory Module Installation
Quantum DXi4700 Installation Guide 89
Figure 76: Installing the DXi4700 Node in the Rack
1
2
3
4
5
Item Description
1 Rear rail standoffs
2 Rear rail J-slots
3 Slide-release lock button
4 Lock lever
5 Inner slide rails
6. Locate the rear rail standoff on each side of the system and lower them into the rear J-slots on the slide
assemblies.
7. Rotate the Node downward until all the rail standoffs are seated in the J-slots.
8. Press the slide-release lock buttons on both rails and slide the system into the rack. (Make sure the
Node is squarely aligned with the rack as you slide it in.)