Quantum DXi4700

Chapter 9: Configuration
Replication Configuration
Quantum DXi4700 User’s Guide 257
Additional Information
l The Source IP field does not accept fully qualified domain names. You must enter a valid IP
address. Make sure this IP address is configured in the allowable sources list on the target DXi.
l When configuring segmented network interfaces, if the source DXi replication, data, and
management interfaces are on the same subnet, you must add a host route on the source DXi to
make sure the replication interface is correctly selected when replicating data to the target DXi
(see Understanding Interface Routing on page 299).
5. Click Apply.
Note: The new target is not automatically added to existing replication schedules. You must add or edit
scheduled events to schedule replication to the new target (see Scheduler on page 265).
Editing a Replication Target
Edit a replication target to change encryption options or the source IP address.
To edit a replication target:
1. Under Target DXis, select the target and click Pause to pause replication.
2. Select the target again and click Edit.
The Edit Target Host window displays (see Figure 161 below).
Note: If you are editing a target, you cannot change the Target Hostname or IP.
Figure 161: Edit Target Host
3. In the Encryption drop-down box, select the type of encryption to use when sending replication data to
the target system (None, 128-bit, 256-bit, or TLS with AES 256).
Important Information
l AES encryption options are available only if the Data-in-Flight license is installed (see License
Keys on page 349).