Quantum DXi4700

Chapter 9: Configuration
Notifications
Quantum DXi4700 User’s Guide 289
l When entering IP addresses, never use an address that is in a reserved IP address range. To
see a list of reserved IP address ranges, click the quick tip icon [?] located near the IP address
field.
4. In the Access Type drop-down box, select the access type for the community:
Get Allows SNMP get operations.
Get/Set Allows both SNMP get and put operations.
5. Select the Community status check box to enable the community.
Or clear the Community status check box to disable the community.
6. Click Apply.
Deleting a Community
Delete an SNMP community if you no longer want the DXi4700 to belong to a group of devices that are
monitored by a common management station.
To delete a community, select the community and click Delete.
Note: You can select multiple communities to delete at once
Test
The SNMP Test page allows you to send a test SNMP trap to verify that SNMP is correctly configured on
the DXi4700.
To access the SNMP Test page, on the SNMP page, click the Test tab (see Figure 181 below).
Figure 181: SNMP Test Page