Chapter 9: Configuration
System
Quantum DXi4700 User’s Guide 328
Note: The reboot takes approximately 20 minutes to complete.
3. Navigate back to the App Specific page (Configuration > System > App Specific). DAE will now
be disabled.
Enable Veeam
Enabling Veeam
l When enabling Veeam for the first time, a password will be required.
l Public keys cannot be configured until after Veeam has been enabled and the system has been
rebooted.
Best Practices Guide
The Best Practices Guide for Veeam Backup & Replication is available at
www.quantum.com/DXi4700BPG
To enable Veeam:
1. Select the Enable Veeam check box (see Figure 209 below).
Figure 209: Application Environment - Enable Veeam
2. Select the Allow login with password check box.
3. Enter the following information:
To Next Page
Loading...
