Quantum DXi4700

Chapter 3: Remote Management
Accessing Remote Management
Quantum DXi4700 User’s Guide 58
Figure 33: Login Window
If the Login window does not display, verify that the IP address is correct and that the network path to
the DXi4700 is valid. Also verify that you are using a supported Web browser. Then try again. If you are
still unable to access the Login window, contact your administrator.
Note: The default IP address is 10.1.1.1. The IP address can be changed during installation using
the Getting Started Wizard or at a later time on the Network page (see Network on page 290).
3. Select the login type and enter the corresponding password.
l Monitor - Allowed to view information on the DXi4700 remote management console but cannot
make changes.
l Administrator - Allowed to view and change information on the DXi4700 remote management
console.
l Service - Allowed to view and change information on the DXi4700 remote management console.
Password changes are not allowed.
l LDAP/AD - Allows users assigned system access through a Lightweight Directory Access Protocol
(LDAP) or Active Directory (AD) server to log into the DXi4700 remote management console.
LDAP/AD must be enabled on the LDAP/AD page for this login type to appear (see LDAP/AD on
page 307).
Note: Passwords are limited to 32 characters. Alphanumeric characters and special characters
are allowed. Passwords can be changed on the Access Control page (see Security on
page 304).
4. Click Login.
5. If you log in as a user assigned to the Admin role (local or LDAP) and there were previous unsuccessful
DXi4700 logins, a dialog box appears indicating the previous number of unsuccessful login attempts for
both the current account and all accounts on the DXi4700(see Figure 34 on the next page).
l Click OK to continue.
l Click View Admin Log to access the Administrative Activity Log page (see Activity Log on