Chapter 4: Configuration Wizards
VTL Wizard
Quantum DXi4700 User’s Guide 81
4. (Optional) To discover additional hosts, repeat Steps 1–3.
5. Click Next to continue.
Figure 49: VTL Wizard: Discover Remote Hosts
Step 5: Map Remote Hosts
1. Enter information about the host access group (see Figure 50 on the next page):
Host Access Information Description
Group Name Enter a name for the group.
Partition Select the partition to associate with the group.
Remote Host Select the host (initiator) to associate with the group.
Target Select the target (port) to associate with the group.
Note: The Backpanel Locations section displays a graphical
representation of the Fibre Channel and Ethernet ports as they
appear on the rear of the system. A dark border displays around the
currently selected target.
To change the LUN numbers assigned to a device, or to map virtual devices to a host, use the
Configuration > VTL > Host Access > Host Mapping page (see Remote Host Mapping on
page 224).
2. (Optional) Select the Use CCL check box to use the Command and Control LUN.
To Next Page
Loading...
