Chapter 4: Configuration Wizards
VTL Wizard
Quantum DXi4700 User’s Guide 82
Note: The CCL (Command and Control LUN) is not used in most environments. This option is
recommended for host access groups that contain an HP-UX host. It can also be used if hosts that
are not assigned to any host access group exist in the SAN. The CCL is accessible to hosts only
through LUN 0.
Caution: If you are not sure if you should use CCL, contact Quantum Customer Support before
you enable this option.
3. Click Add.
4. (Optional) To map additional hosts, repeat Steps 1–3.
5. Click Next to continue.
Figure 50: VTL Wizard: Map Remote Hosts
Step 6: Confirm
1. Review the settings you selected to make sure they are correct (see Figure 51 on the next page). If
necessary, click Previous to return to a previous step to make changes.
2. To make changes to a VTL partition, media, or host access group you added, first select the item and
click Delete to delete it. Then click Previous to return to the appropriate step and add a new item.
3. After you have confirmed all settings, click Finish. The wizard configures the DXi4700 with the settings
you selected.
To Next Page
Loading...
