Quantum DXi4700

Chapter 4: Configuration Wizards
OST Wizard
Quantum DXi4700 User’s Guide 86
Step 3: Add LSUs
1. Enter information about the LSU (see Figure 54 on the next page).
LSU Information Description
Storage Server Select the storage server that will contain the new LSU.
Use Available Capacity Select this option to add an LSU that uses the available capacity on the
system.
You cannot add an available capacity LSU to a storage server that
already contains an LSU. Also, if you add an available capacity LSU to a
storage server, you cannot add additional LSUs to that same storage
server.
Note: After you add an LSU that uses the Available Capacity
option, you cannot change the LSU to use the Specific Capacity
option. Instead, you must delete the LSU, then add a new LSU and
choose the Specific Capacity option (see Deleting an LSU on
page 246).
Specify Capacity Select this option to specify the physical capacity of the LSU, and then
enter the following information.
l LSU Name - Enter the name of the LSU.
l Physical Capacity - Enter the physical capacity of the LSU (1 to
1048576 GB).
2. Click Add.
The LSU displays in the LSUs Added table.
3. (Optional) To add additional LSUs, repeat Steps 1–2.
To remove an LSU, select it in the LSUs Added table and click Delete.
4. Click Next to continue.
Additional Information
l The LSU limit is 1000.
l To configure the LSU for Automatic Image Replication, use the Configuration > OST > LSU page
(see LSU on page 241).