Quantum DXi4700

Chapter 4: Configuration Wizards
Replication Wizard
Quantum DXi4700 User’s Guide 91
Figure 58: Replication Wizard: System
Step 3: NAS Share (DXi4700 NAS and Multi-Protocol Configurations
Only)
1. Select a NAS share in the Replication Settings for NAS Shares section to manage its replication
settings (see Figure 59 on page 93).
Note: For help adding NAS shares to the system, use the NAS Configuration Wizard (see NAS
Wizard).
2. To configure the share to replicate its data to another DXi system, enter the following information under
Send:
a. Select the Enable replication for selected share check box to enable replication for the share.
b. (Optional on CIFS/SMB and NFS shares only) Select the Enable Directory/File based
replication to target check box to enable Directory/File Based Replication for the share, and then
enter a Sync ID in the box.
With Directory/File Based Replication, a file is automatically replicated when it is closed or a period
of time after it is modified. After replication, the replicated files are immediately available on the
target system.