Chapter 4: Configuration Wizards
Replication Wizard
Quantum DXi4700 User’s Guide 94
a. (Optional) Select the Enable Cartridge based replication to this DXi check box to enable
Cartridge Based Replication for the partition, and then enter a Sync ID in the box.
The Sync ID is used to identify the source partition that will send replicated data to the target
partition. The Sync ID must be identical to the Sync ID of the source partition on the source system.
b. If you enabled Cartridge Based Replication, select an Access option:
Access Option Description
Locked The partition is not allowed to receive new Cartridge Based Replication data.
Unlocked The partition is allowed to receive new Cartridge Based Replication data.
Note: You cannot configure a partition to both send and receive Cartridge Based Replication
data.
4. Click Apply.
5. (Optional) To configure additional partitions for replication, repeat Steps 1–4.
6. Click Next to continue.
Figure 60: Replication Wizard: VTL Partitions
Step 4: Confirm
1. Review the settings you selected to make sure they are correct. If necessary, click Previous to return to
a previous step to make changes (see Figure 61 on the next page).
2. After you have confirmed all settings, click Finish. The wizard configures the DXi4700 with the settings
you selected.
To Next Page
Loading...
