Initializing the Storage Arrays and Software
Quantum DXi6900 Installation Guide 50
b. Right-click the network connection that corresponds to the Ethernet port on the computer (for
example, Local Area Connection), and click Properties.
c. Select Internet Protocol Version 4 (TCP/IPv4) in the list of connections, and then click
Properties.
The Internet Protocol Version 4 (TCP/IPv4) Properties window displays (see Figure 41 below).
Figure 41: Internet Protocol Version 4 (TCP/IPv4) Properties Window
d. Select Use the following IP address and then enter the following information:
Caution: Before changing the IP address information, write down the original settings. This
will be used later to reset the network configuration.
l IP address - 10.17.21.200
l Subnet mask - 255.255.255.0
e. Click OK, and then click Close.
f. Wait at least two minutes for the computer to set the IP addresses on the local computer.
4. Using a terminal emulation program that supports SSH (like PuTTY), connect to the Node with the
following IP address: 10.17.21.1
The terminal emulation window displays.
5. Enter ServiceLogin for the user name and then enter the default service password (Qa@SmX7!).
The command prompt displays.
To Next Page
Loading...
