Quantum DXi6900

Initializing the Storage Arrays and Software
Quantum DXi6900 Installation Guide 51
6. At the command prompt, type the following command and press <Enter>:
sudo -i sh
This command creates a shell with root access.
7. At the command prompt, type the following command and press <Enter>:
sh /opt/DXi/scripts/service.sh
The Service Menu displays (see Figure 42 below). The heading at the top of the Service Menu
indicates the system is in PTO Mode.
Figure 42: Service Menu
*** Service Menu [PTO Mode]
0) Hardware Configuration >>> - Tools for Configuring Hardware.
1) Serial Numbers >>> - Tools for Node, System and OUI Serial Numbers.
2) Install Application Software - Install Application Software.
3) More Tools >>> - Miscellaneous Tools.
4) Pick to Order (PTO) >>> - Initial DXi assembly and configuration.
8. Type the option number for Pick to Order (PTO) and press <Enter>.
The Pick To Order Menu displays (see Figure 43 below).
Figure 43: Pick to Order Menu
*** Pick to Order Menu [PTO Mode] ***
0) Discover Hardware - Step 0.
1) Check Hardware >>> - Step 1.
2) RAID initialize - Step 2.
3) Software initialize - Step 3.
4) Finalize PTO - Step 4.
5) -----------------------------
6) Enable PTO - Stop DXi stack, switch into PTO mode.
7) Disable PTO - Turn off PTO mode, enable DXi stack.
8) Reset PTO - Start over with PTO.