Quantum DXi6900

Initializing the Storage Arrays and Software
Quantum DXi6900 Installation Guide 55
The system displays information about attached Array Modules (RBODs) and Expansion Modules
(EBODS) (see Figure 47 below).
Make sure all of the installed RBODs and EBODs are detected. If one or more storage arrays are not
detected, resolve the issue before continuing (see Troubleshooting on page 80).
Figure 47: PTO: Check NetApp Trays
Array: 1
Number Of Disk Drives: 24
Controller: A
Controller: B
EBOD: 0
ESM Canister: A (Left)
ESM Canister: B (Right)
External Storage is OK.
5. On the Hardware Check Menu, type the option for Check HBAs and press <Enter>.
The system displays information about all expansion cards installed in the Node (see Figure 48 below).
Note: The expansion card display below is an example. The actual cards assigned to each PCI
slot will depend on the configuration option selected for the DXi (see Table 2 on page 9).
Make sure all of the installed expansion cards are detected. If one or more expansion cards are not
detected, or are detected in the wrong slots, resolve the issue before continuing (see Troubleshooting
on page 80).
Figure 48: PTO: Check HBAs
PCI Slot: 1, Intel Corporation Ethernet 10G 2P X520 Adapter (rev 01)
PCI Slot: 2, -
PCI Slot: 3, QLogic Corp. ISP2532-based 8Gb Fibre Channel to PCI Express HBA
(rev 02)
PCI Slot: 4, -
PCI Slot: 5, LSI Logic / Symbios Logic SAS2116 PCI-Express Fusion-MPT SAS-2
[Meteor] (rev 02)
PCI Slot: 6, LSI Logic / Symbios Logic SAS2116 PCI-Express Fusion-MPT SAS-2
[Meteor] (rev 02)
PCI Slot: 7, QLogic Corp. ISP2532-based 8Gb Fibre Channel to PCI Express HBA
(rev 02)