Quantum QN-I-270 User Manual

8 | www.qntmnet.com
Step 3 - Setting up device IP address
Click “Configure” and set the device IP address by selecting the required options.
 Connectivity Mode – Select the connectivity mode.
 Protocol - DHCP, Static or PPPoE
 Interface – Select interface
 VLAN Assignment- Enable parameter. Enter VLAN ID and click “Fetch IP Address” to
get the respective IP in case of VLAN setup is required.
Figure 3
Click “Proceed” to apply configuration and turn to the next page.

Quantum QN-I-270 Specifications

General

Brand	Quantum
Model	QN-I-270
Category	Wireless Access Point
Language	English