QXS-412/424 Next steps
QX and QXS 12- and 24-Drive Rackmount Install Guide 20
Figure 19: Installing bezel (representative example)
Note: When the chassis is in operation, the bezel must be attached in order to provide EMI
protection for the drives.
3. Install any additional options as described in instructions provided with the options.
4. Connect chassis, power up the system, and connect hosts as described in the Setup Guide.
5. Upon successful completion of the hardware installation, use the storage system’s web-based
management interface to configure and provision the system.
6. See the Quantum website for additional information.
To Previous Page
Loading...
Need help?
General