QXS and Cabinet Information 3
Figure 3 Standard Cabinet
Standard features of the cabinet include:
• Front and rear door that can be closed and locked
• Vertical rails, with mounting holes, to allow installation of storage
• 40U high cabinet and 19 inches/48.3cm wide
• Four rolling coasters/wheels
• Four leveling pads (bottom of cabinet)
• A stabilizing foot (after installation of permanent location)
• Access for storage cabling
• AC or DC power source (2 each)
1 Front door 2 Rear door
3 Vertical support rails 4 Air vent
WARNING! Risk of bodily harm and/or injury. Comply with the following:
• Always populate the cabinet from bottom to top to prevent tipping.
• If a cabinet must be moved, use adequate personnel and/or a forklift to relocate the cabinet.
• Push the cabinet from the front when moving.
• A fully populated cabinet can weigh almost 3000 pounds (1360.777kg).
• Cabinets are hard to move, even on a flat surface/floor.
• If moving a cabinet on an incline, always remove the top-half storage arrays/devices to prevent
from tipping.
To Next Page
Loading...
