Quantum Scalar i500 - Page 16

Quantum Scalar i500: Rackmount Kit Installation
6-01492-04 Rev A
December 2013
16 Installing Additional Modules Into the Rack
Figure 9 Thumbscrew Location
in Module
9 Install the right rack ear (see Figure 10 on page 17). At the front of the
library:
a Open the I/O station door. At the lower right corner of the module is a
vertical slot. Insert the hinge of the right rack ear into the slot and then
position the holes of the rack ear flush with the rack rail.
Front of Control
Module
Rear of Control
Module
Thumbscrews
Thumbscrews