Quasar VHQ-940 User Manual

*Important: If the remote control POWER, ACTION, PROG, CHA/Y , INDEX, NUMBERED keys, INPUT,
TAPE POSITION, or ADD/DLT button does not work when pressed, press the VCR button on the
remote and try the button again.
Cable Box Setup Process of Recordin:
1 Display menu.
Press ACTION.*
Select SET UP O CL) Select SET UP CHANNEL.
SET UP VCR 1) Press AY to
SET UP FEATURE select. |
-— 2) Press > to 3
IDIOMA/ LANGUE: ENGL I SH :
SELECT:A Y KEY | display. D
SET :» KEY
END :АСТІОМ KEY JJ
Ф
3
--——- SET UP CHANNEL ----) Select CABLE/DSS BOX a
ANTENNA : CABLE SET UP. SELECT/ -
CHANNEL САРТ ION SET &
WEAK SIGNAL DISPLAY :OFF 1) Press AY to t A:PLAY
select. 5 W:STOP cC
VCR Plus+ CH SET UP »:FF w
SELECT:
Y
KEY
2)
Press
№
to
5
SET :» KEY ;
END :ACTION KEY display. (Q
<
Ф,
JU
SELECT HOOKUP Select your hookup y
m pA occum n
VORPCABLE/DSS BOXPTV method. 1) P AY: С
VCR» ress O
select. 1 ACTION p
SELECT:A Y KEY 2) Press № to set. 6 «
SET ¡Pb KEY o
END :АСТІОМ KEY =>
• If CABLE/DSSBOX VCR PTV, 5
go to step 5.
If other, press ACTION three
times and go to page 16.
SELECT HOOKUP | Select cable box or DSS
CABLE/DSS BOXPVCR»TVY | receiver output channel.
1) Press АЎ to Mode! VHQ-960 remote is shown here.
CABLE/DSS BOX OUTPUT CH lect
select.
SELECT:A
Y
KEY
2)
Press
Y»
to
SET :4 > KEY enter.
END : ACTION KEY
* |f necessary, refer to your Cable
Box/DSS manual.
• If you are using Audio/Video jack
connections, select and set
"VIDEO OUT" as output channel.
VCR Plus+ and PlusCode
End
setup.
are
registered
trademarks
of
| | Gemstar Development
Press ACTION twice. Corporation. The VCR Plus+
system is manufactured
under license from Gemstar
Development Corporation.
15

Quasar VHQ-940 Specifications

General

Brand	Quasar
Model	VHQ-940
Category	VCR
Language	English