Content of the manual BES X User Interface Manual, EASYKEY
4
4 Rev. 2
Content of the manual
This manual shows all of the functions that can be performed from the EasyKey console with BES X Core
scoring system.
All of these functions can be enabled or disabled from ConquerorPRO.
If some of the functions described during this manual are not present in your center, please contact your
local dealer/distributor in order to get more information.
BES X EasyKey
The following picture show the QubicaAMF EasyKey bowler terminal model range for the BES X system.
The keypad includes:
Alphanumeric buttons: to insert names and numbers.
White Arrows buttons: to select graphic options and to move the writing cursor.
Menu button: to access the user interface.
Symbols button: to enter symbols, special characters and accents.
Terminals can be installed on a “per lane” or a “per lane pair” basis.
When the EasyKey console is based on a single keypad simultaneously serving two lanes, the choice of the
active lane may be performed through the LEFT/RIGHT LANE selection button, located on the lower angles
of the terminal.
To choose a lane, press the LEFT or RIGHT LANE button on the terminal while the lanes are open; the red
arrow button related to the selected lane will blink, while the other one will turn off. To select the other
lane press the red arrow button related to the other lane even if it is turned off.
If no button is pressed, after 10 seconds the keypad goes idle.
To turn on the keypad press again one of the LEFT/RIGHT LANE keys.
To Next Page
Loading...