Need help?Do you have a question about the QubicaAMF BES X and is the answer not in the manual?
General| Type | Bowling Scoring System |
|---|---|
| Manufacturer | QubicaAMF |
| Model | BES X |
| Power Supply | 100-240VAC, 50/60Hz |
| Connectivity | Ethernet |
| Software | BES X Software |
| Storage Temperature | -20°C to 60°C (-4°F to 140°F) |
Description, installation notes, and workings of the 4HD/5HD-HUB units.
Description, installation notes, and workings of the 4HD/5HD-CPU units.
Configuration for lanes without any specific bowler console installed.
Overview of the EasyKey console and its basic functions.
Configuration details for using an EasyKey console in a pair setup.
Details on EasyKey Lane and Twin console configurations for lanes.
Overview of the SuperTouch console, a touch screen interface.
Configuration for SuperTouch consoles in a pair setup.
Configuration for SuperTouch consoles on a lane basis.
Step-by-step guide for installing single pedestals.
Visual guide on mounting an EasyKey console onto a single pedestal.
Visual guide on mounting a SuperTouch console onto a pedestal.
Guidelines for installing the scoring network switches and cabling.
Scoring network configuration for centers with up to 12 lanes.
Scoring network setup for larger centers or split lane configurations.
Scoring network setup for very large centers or split lane configurations.
Table of IP addresses assigned to various BES X system components.
Correct wiring procedures for LCOM devices and connectors.
Steps for safely disconnecting and replacing LCOM devices.
Troubleshooting guide for identifying and resolving LCOM line issues.
Specifications and compatibility requirements for overhead monitors.
Guide to enable "Just Scan" and "HDMI-CEC" on specific monitor models.
Guidelines for installing and configuring the front desk computer.
Details for installing the ConquerorPRO Residential Edition software.
Explanation of the Lanes Control Box Service for IP address management.
Wiring and configuration steps for the 288201089 video server.
Wiring details for the 288201034 single channel video server.
Diagram showing the connection for the IR Fly console.
Diagram showing the connection for the IR Micro I console.
Diagram showing the connection for the IR Micro II console.
Diagram showing the connection for the standard Fly console.
Step-by-step guide for the initial system startup and configuration.
Explanation of parameters within the lane setup screen in ConquerorPRO.
Explanation of the information displayed on the lane monitors during boot-up.
A comprehensive list of error codes and their meanings during system boot-up.
Procedures for powering the scoring system on and off daily.
Steps to boot the system in emergency when the server PC crashes.
Guide for uploading software updates or reinitializing system components.
Procedure for uploading animations to the CPU units for display.
Steps to configure audio devices for the Virtual Waiter feature.
Introduction to the BES X Dual Mode and its requirements.
Diagrams illustrating the physical layout for Dual Mode installations.
Specific software setup parameters for Dual Mode configuration.
Step-by-step instructions for replacing the 4HD/5HD-HUB unit.
Step-by-step instructions for replacing the 4HD/5HD-CPU unit.
Procedure for replacing a faulty EasyKey console.
Procedure for replacing a faulty SuperTouch console.
To Next Page