BES X Installation Manual, Rev.9, Jun 2018 General Installation Notes
P/N: 400288005 7
General Installation Notes
For devices directly connected to the power, it is necessary to check that the electrical capacity of the
system is suitable for the maximum power requirements of the equipment (as indicated on the labels of
the equipment).
Always open the circuit breaker and disconnect the power plug from the powered units before looking for,
and clearing, any problem.
To reduce the risk of fire or electrical shock, do not expose this equipment to moisture.
This appliance must be positioned such that the mains supply cord connector is accessible after installation.
Be aware of the voltage being supplied to the equipment (i.e. from 100V to 240V) and that the equipment
is set for the correct voltage (when applicable).
Failure to set the equipment for the correct voltage will result in damage to the equipment.
The electrical safety of the equipment is obtained only when the equipment is connected to an effective
GROUNDING SYSTEM (in accordance with the existing electrical codes and safety regulations).
It is necessary to have the power and grounding inspected by a licensed and certified electrician.
The manufacturer cannot be responsible for possible injury, damages or malfunctioning of the equipment
due to the absence of or improper grounding of the equipment.
To Next Page
Loading...
Need help?
General
