QubicaAMF BES X - Supertouch Console Brief Description; Supertouch Pair Console

BES X Installation Manual, Rev.9, Jun 2018 BES X system configurations
P/N: 400288005 35
3.5 - SuperTouch console brief description
The SuperTouch console is the touch screen console. It gives access to all of the on-lane functions of the
BES X system.
The SuperTouch console is InterCom ready. This fact does not means that the InterCom system will be
available on the lanes, because the InterCom have to be purchased separately (Q-Com system).
There are two versions for the SuperTouch console: SuperTouch console (P/N: 288150024) and SuperTouch
Ver.2 (P/N: 288150026). The main differences between the two versions for these consoles is that the
SuperTouch consoles (P/N: 288150024) needs to be connected to the 4HD/5HD-HUB unit using two
network cables, while the new SuperTouch Ver.2 console (P/N: 288150026) needs to be connected to the
4HD/5HD-HUB unit using one network cable.
It is possible to install the new SuperTouch Ver.2 console (P/N: 288150026) along with the old SuperTouch
(P/N: 288150024).
3.6 - SuperTouch Pair console
In this configuration on each pair of lanes there will be installed:
 the camera (Q-Vision or T/M-Vision);
 the pinspotter interface;
 other optional LCOM devices (Bumper interface, Q-FOUL, TMR, etc…);
 one 4HD/5HD-HUB;
 one 4HD/5HD-CPU;
 the overhead monitors (i.e.: two overhead monitors);
 one SuperTouch console.
The camera, the pinspotter interface and the other optional LCOM devices are connected to the 4HD/5HD-
HUB via the LCOM cable (Refer to section “6 – LCOM Line” for further information).
The L1 port of the 4HD/5HD-CPU is connected to the L1 port of the 4HD/5HD-HUB via a network cable.
Each overhead monitor is connected to the proper port of the 4HD/5HD-CPU unit with a HDMI cable. If the
monitors does not support commands by the HDMI, a serial communication cable (PN: 288401007) has to
be installed between the overhead monitor and the 4HD/5HD-CPU in order to be controlled directly from a
ConquerorPRO computer.
The SuperTouch Ver.2 (PN: 288150026) is connected to:
 L4 port of the 4HD/5HD-HUB through a network cable (yellow cable);
Or
The SuperTouch (PN: 288150024) is connected to:
 L4 port of the 4HD-HUB through a network cable (yellow cable);
 P1 port of the 4HD-HUB through a network cable (blue cable): connect the network cable on the
4HD-HUB side to the 288401035 cable adapter then the 288401035 cable adapter to the P1
connector of the 4HD-HUB unit.
Each console has to be connected to ground. Please refer to the section “5 – Suggested ground
connection” of the BES X – PRE-Installation Manual for further information.