QubicaAMF BES X - How to Replace an Easykey Console; How to Replace a Supertouch Console

Replacements BES X Installation Manual, Rev.9, Jun 2018
158
158 P/N: 400288005
16.3 - How to replace an EasyKey console
This is the procedure to follow in order to replace a faulty EasyKey console:
 Turn off the 4HD/5HD-HUB by unplugging the power cord from the 4HD/5HD-HUB unit, in order to
turn off the couple of lanes where the faulty EasyKey console is installed;
 Disconnect and remove the faulty EasyKey console from the pedestal;
 Fix and connect the new EasyKey console in the same way as the old one.
Check that all the cables are connected;
 Turn on the new 4HD/5HD-HUB.
16.4 - How to replace a SuperTouch console
This is the procedure to follow in order to replace a faulty SuperTouch console:
 Turn off the 4HD/5HD-HUB by unplugging the power cord from the 4HD/5HD-HUB unit, in order to
turn off the couple of lanes where the faulty SuperTouch console is installed;
 Disconnect and remove the faulty SuperTouch console from the pedestal;
 Fix and connect the new SuperTouch console in the same way as the old one.
Check that all the cables are connected;
 Turn on the new 4HD/5HD-HUB.
 Wait until on the overhead monitors will be displayed “Test LCD R Error 199” or “Test LCD L Error
199” or when the lane boot up properly.
 In ConquerorPRO go to the ConquerorPRO main menu: Setup / Technical Setup / Upload to Lanes
 Click on the “Lanes selected” box.
 In the screen that appears select ONLY the couple of lanes where the SuperTouch console has been
replaced.
 Click on the “OK” button.
 On the “Upload to Lanes” screen click on the “Reinitialize” button.