T. 0.01 54
MAY 21st 1820
610325104 KIT FOR MOUNTING
ONE BES X SINGLE PEDESTAL
(286002847)
1
2
3
Use this kit with pedestal 286002861, 286002862, 286002863, 286002864 or 286002865 secured
to floor. This kit is for the purpose of mounting one X pedestal, where the cable entryBES
location is not exactly under the pedestal position.
INSTALLATION INSTRUCTIONS:
1. Separate the two piece cable cover (2).
2. Cut the cable cover base part to length as necessary to locate the cable cover on the floor
between the 4HD/5HD console and the cable entry location.
3. Remove the adhesive strip liners from the bottom of the cable cover base and secure the
cable cover base part to the floor in the desired location.
4. Drill 5/32" (4mm) holes a minimum of 1.5" (40mm) deep thru the cable cover base part into
the floor close to each end and approximately every 12' (300mm).
5. Use the holes to secure the cable cover base part to the floor with anchor screws (3).
6. Install cables in the pedestal assembly and place cables in the cable cover base part.
7. Replace the existing rear base cover 286002855 from the pedestal assembly 286002861,
286002862, 286002863, 286002864 or 286002865 with the rear base cover
FMW 289002848 (1).
8. Routing the cables thru the opening in the rear base cover FMW.
9. Cut the cable cover top part (2) to fit snugly between the rear base cover FMW (1) and the
cable entry.
10. Install the cable cover top part over the cables in the cable cover base part.
286002848
286002849
Rear base cover FMW
Cable cover
862137200 ANCR BL 3/16 x 1.25 BC
1
1
5
PARTS LIST
ITEM
1
2
QTY P/N DESCRIPTION
3
To Next Page
Loading...