Front Desk BES X Installation Manual, Rev.9, Jun 2018
104
104 P/N: 400288005
9.3 - Lanes Control Box Service
The Lanes Control Box Service (called also Matrix Configuration service or MxServer) is the program that
manages the allocation of IP addresses of the 4HD/5HD-CPU boxes each time they boot up.
To setup the lane control box service you have to open the SYSTEM tab under the icon SETUP-CENTER
SETUP.
In the field under B.E.S. Server IP you should insert the IP of the Conqueror Server computer where the
Lanes Control Box Service is installed, the IP should be (from Conqueror 6) 192.168.71.1 (in the case of a
front desk computer that acts as the Server) or 192.168.71.99 (in the case of a Separate Server), while in
the case of early Conqueror versions it should be 192.168.1.1 (in the case of a front desk computer that
acts as the Server) or 192.168.1.99 (in the case of a Separate Server).
In the field under B.E.S. Lane Subnet address you should insert the IP address of the second network card
of the ConquerorPRO computer where the Lanes Control Box Service is installed, the IP should always be
192.168.216.1
WARNING: You can have only one Lanes Control Box Service running per Bowling Center
If these 2 IP addresses are not set, the Conqueror will give an error each time the system boots up.
In order to be able to properly manage the 4HD/5HD-CPU the Score Shared Path field must be pointed
towards the score shared folder of the computer where the Lanes Control Box Service is installed.
In order to apply any change on this screen press SAVE, ConquerorPRO will restart.
To Next Page
Loading...