System boot up sequence BES X Installation Manual, Rev.9, Jun 2018
134
134 P/N: 400288005
13.1 - Boot-up screen description
During the boot-up of the system, it will be displayed the following picture (note that this picture is only an
example):
This is an example of the boot-up screen that is displayed on the lane monitors during the boot-up
sequence of the BES X system.
1. In this part of the screen there will be written the boot-up process information
(“system booting”, “please reinitialize the system”, etc.);
2. In this square there will be written the serial number (S/N) of the 4HD/5HD-CPU and
the IP address assigned to that unit.
3. In this area there will be displayed the operations performed by the system during the
boot-up process.
4. In this area there will be displayed the monitor number. NOTE: this is NOT the lane
number, but the number for the monitor of that pair of lane, so the monitor on the
odd lane is always 1 and the monitor on the even lane is always 2.
To Next Page
Loading...