QubicaAMF BES X - How the 4 HD;5 HD-HUB Works

System components BES X Installation Manual, Rev.9, Jun 2018
12
12 P/N: 400288005
 L3 ODD console COM line: Network connection with POE for the odd lane console (EasyKey or
SuperTouch models only). When a single console per pair of lanes is installed, this output is not
used.
 L4 EVEN/SINGLE console COM line: Network connection with POE for the even lane console
(EasyKey or SuperTouch models only). This output is always used when the console have to be
installed, even in the case of single console per pair of lanes.
 PRESENT ONLY ON THE 4HD-HUB: P1 LCD console backlight: Power out for SuperTouch console
backlights NOT used with SuperTouch Ver.2 consoles (P/N: 288150026).
 PRESENT ONLY ON THE 4HD-HUB Rev.2: D1 Console Data ODD: For OLD console only. Power
supply, XCOM and input / output audio channels for the odd lane console (Micro I, Micro II or Fly
console models only). When a single console per pair of lanes is installed, this output is not used.
 PRESENT ONLY ON THE 4HD-HUB Rev.2: D2 Console Data EVEN / SINGLE: For OLD console only.
Power supply, XCOM and input / output audio channels for the even lane console (Micro I, Micro II
or Fly console models only). This output is always used when the console have to be installed, even
in the case of single console per pair of lanes.
 PRESENT ONLY ON THE 5HD-HUB: D1 Pinspotter COM line: Connection to TMS pinspotter chassis.
 PRESENT ONLY ON THE 5HD-HUB: D2 YCOM COM line: Connection for Control I/O 3 ONLY.
Connectors on the upper side of the 4HD-HUB unit:
 N1 Network: Standard network connection to the scoring network.
4HD-HUB LEDs:
Each RJ45 port is provided of two colored LED (orange and green).
 N1:
o Green: The LED is ON when a link is present.
o Orange: The LED flashes when is transmitting or receiving data from the network.
 L1, L2, L3 and L4:
o Green: Power Over Ethernet status. When the LED is ON, it indicates the 4HD-HUB is
providing the correct power over Ethernet to the connected device.
o Orange: The LED flashes when is transmitting or receiving data from the network.
 4HD-HUB D1 and D2:
o Green: Power output status. When the LED is ON, it indicates the CPU is providing the
correct power to the connected device
o Orange: XCOM communication line. The LED flashes when the XCOM line is running.
 5HD-HUB D1 and D2:
o Tx: The LED flashes when transmitting data from the connected device.
o Rx: The LED flashes when receiving data from the connected device.
1.1.5 - How the 4HD/5HD-HUB works
The communication between the 4HD/5HD-HUB unit and the front desk is based on the TCP/IP protocol.
The operation of the 4HD/5HD-HUB is similar to a normal network hub, with the additional functionality to
give power to all the lane devices (4HD/5HD-CPU, SuperTouch, EasyKey, pinspotter interface, etc.)
connected to it. The turning on/off of the 4HD/5HD-HUB will be the turning on/off of the entire pair of
lanes devices (4HD/5HD-CPU, SuperTouch, EasyKey, pinspotter interface, etc.).