BES X system configurations BES X Installation Manual, Rev.9, Jun 2018
32
32 P/N: 400288005
3.4 - EasyKey Lane and EasyKey Twin console
In this configuration on each pair of lanes there will be installed:
the camera (Q-Vision or T/M-Vision);
the pinspotter interface;
other optional LCOM devices (Bumper interface, Q-FOUL, TMR, etc…);
one 4HD/5HD-HUB;
one 4HD/5HD-CPU;
the overhead monitors (i.e.: two overhead monitors);
For the console there are two options:
EasyKey Lane: two EasyKey console on two different stands (please refer to table T.10.027);
EasyKey Twin: two EasyKey console on the same stand (please refer to table T.10.028).
The camera, the pinspotter interface and the other optional LCOM devices are connected to the 4HD/5HD-
HUB via the LCOM cable (Refer to section “6 – LCOM Line” for further information).
The L1 port of the 4HD/5HD-CPU is connected to the L1 port of the 4HD/5HD-HUB via a network cable.
Each overhead monitor is connected to the proper port of the 4HD/5HD-CPU unit with a HDMI cable. If the
monitors does not support commands by the HDMI, a serial communication cable (P/N: 288401007) has to
be installed between the overhead monitor and the 4HD/5HD-CPU in order to be controlled directly from a
ConquerorPRO computer.
The EasyKey console on the ODD lane is connected to the L3 port of the 4HD/5HD-HUB through a network
cable (grey cable).
The EasyKey console on the EVEN lane is connected to the L4 port of the 4HD/5HD-HUB through a network
cable (yellow cable).
The difference between the two console configuration are in the quantity of stands and on the quantity of
speakers installed, because each stand has only one speaker. Due to this fact the connection cable for the
speaker is slightly different between the two situations.
Each console has to be connected to ground. Please refer to the section “5 – Suggested ground
connection” of the BES X – PRE-Installation Manual for further information.
To Next Page
Loading...