QubicaAMF BES X - How to Enable the Just Scan (or Screen Fit) and HDMI-CEC Capabilities on Monitors Supplied by Qubicaamf

BES X Installation Manual, Rev.9, Jun 2018 Overhead monitors
P/N: 400288005 91
7.3 - How to enable the “Just Scan” (or “Screen Fit”) and
“HDMI-CEC” capabilities on monitors supplied by
QubicaAMF
With monitors supplied by QubicaAMF follow one of the procedures listed below, according to the brand /
model of the monitors, in order to enable the “Just Scan” (or “Screen Fit”) capability.
ACCUVISION MONITORS Gen.3 and Gen.4:
How to enable the control “HDMI-CEC”:
 Enter the main menu of the monitor by pressing once the “Menu” button on the remote control.
 Once the main menu screen has appeared on the monitor, press in a fast sequence the following
buttons on the remote control: “Menu”, “9”, “6”, “3”, “2”.
 Navigate to the “TV Control” setting and press “OK” on the remote control.
 Set the control “HDMI-CEC” (this setting lets the control commands to be executed through the
HDMI cable).
 Once finished, press many times the “Menu” button on the remote control to exit from the menu.
ACCUVISION MONITORS Gen.2, Gen.3 and Gen.4:
How to enable the “JUST SCAN” option:
If the image displayed on the monitor is larger than the monitor screen, follow this procedure in order to
have a correct aspect ratio:
 Press once the “Menu” button on the remote control.
 Enter the main menu of the monitor by pressing once the “Menu” button on the remote control.
 Once the main menu screen has appeared on the monitor, press in a fast sequence the following
buttons on the remote control: “Menu”, “9”, “6”, “3”, “2”.
 Navigate to the sub menu “Aspect Ratio”.
 Select “Just Scan” and press “OK” on the remote control.
 Once finished, press many times the “Menu” button on the remote control to exit from the menu.
SAMSUNG MX SERIES MONITORS:
How to enable the “JUST SCAN” (or “Screen Fit”) option:
If the image displayed on the monitor is larger than the monitor screen, follow this procedure in order to
have a correct aspect ratio:
 Enter the main menu of the monitor by pressing once the “Menu” ( ) button on the remote
control.
 Navigate to the “Picture” menu, using the arrow buttons and press the “Enter” ( ) button on the
remote control.
 Navigate to the “Size” sub menu and press the “Enter” ( ) button on the remote control.
 Select the “Just Scan” (or “Screen Fit”) option and press the “Enter” ( ) button on the remote
control.
 Once finished, press many times the “Exit” ( ) button on the remote control to exit from the
menu.