System components BES X Installation Manual, Rev.9, Jun 2018
16
16 P/N: 400288005
1.2 - 4HD-CPU and 5HD-CPU
IMPORTANT NOTE: the 5HD-CPU unit, P/N: 288250023, is supported by ConquerorPRO version 12 or
higher.
The 4HD-CPU and 5HD-CPU are the graphic engine of the BES X scoring system. Their functionality is to
display the scoring grids, the animations, the different environments, etc… They are connected to the
4HD/5HD-HUB unit with a single network cable and must be installed near the overhead monitors.
These units can manage up to two independent video outputs for the scoring system, but can control
(monitor ON/OFF, channel change, etc. only on supported monitors) up to three monitors (two for the
scoring system and one with an independent video signal). They communicates and takes power from the
4HD/5HD-HUB unit through the network cable connected to the L1 connector and are connected to the
overhead monitors through the HDMI connectors. These units must be installed near the overhead
monitors, in particular the 4HD-CPU and the 5HD-CPU must be installed on the monitor frames if the
monitor frames are supplied by QubicaAMF. If the monitor frames are not supplied by QubicaAMF, the
4HD-CPU or the 5HD-CPU unit shall be fixed to a vertical surface NEAR the overhead monitors, in an area
that ensures the correct air recirculation, with the L1 connector facing upwards.
There are two versions for the 4HD-CPU unit with part numbers: 288250017 and 288250020.
There is one version of the 5HD-CPU unit, with part number: 288250023.
1.2.1 - Installation notes
The 4HD/5HD-CPU unit communicates with the 4HD/5HD-HUB via a standard network with POE. The
connection between the 4HD/5HD-CPU and the 4HD/5HD-HUB is between the L1 port of the 4HD/5HD-CPU
unit and the L1 port of the 4HD-HUB, as explained in this manual.
In the case of monitors and monitor frames provided by QubicaAMF the 4HD/5HD-CPU unit must be
installed on the monitor frames. If the monitor frames are not supplied by QubicaAMF, the 4HD/5HD-CPU
unit shall be fixed to a vertical surface NEAR the overhead monitors, in an area that ensures the correct air
recirculation, with the L1 connector facing upwards.
The connection between the 4HD/5HD-HUB and the 4HD/5HD-CPU is made with a different cable,
according to the distance between the units:
Up to 50 m (up to 150 ft.): one AWG-24 Cat. 5e network cable;
More than 50 m (more than 150 ft.): one solid AWG-23 Cat. 6 cable.
These cables are provided by QubicaAMF.
To Next Page
Loading...