Quectel BG95 Series

LPWA Module Series
BG95 Hardware Design
BG95_Hardware_Design 10 / 80
1.2. FCC Certification Requirements.
According to the definition of mobile and fixed device is described in Part 2.1091(b), this device is a
mobile device.
And the following conditions must be met:
1. This Modular Approval is limited to OEM installation for mobile and fixed applications only. The antenna
installation and operating configurations of this transmitter, including any applicable source-based time-
averaging duty factor, antenna gain and cable loss must satisfy MPE categorical Exclusion Requirements
of 2.1091.
2. The EUT is a mobile device; maintain at least a 20 cm separation between the EUT and the user’s
body and must not transmit simultaneously with any other antenna or transmitter.
3.A label with the following statements must be attached to the host end product: This device contains
FCC ID: XMR201910BG96M3.
4.To comply with FCC regulations limiting both maximum RF output power and human exposure to RF
radiation, maximum antenna gain (including cable loss) must not exceed:
❒ GSM850:≤8.571 dBi
❒ GSM1900:≤10.030dBi
❒ Catm LTE Band2/25:≤11.000dBi
❒ Catm LTE Band4/66:≤8.000dBi
❒ Catm LTE Band5/26:≤12.541dBi
❒ Catm LTE Band12/85:≤11.798dBi
❒ Catm LTE Band13:≤12.214dBi
❒ Catm LTE Band14:≤12.272 dBi
❒ NB LTE Band2/25:≤11.000dBi
❒ NB LTE Band4/66:≤8.000dBi
❒ NB LTE Band5/26:≤12.541dBi
❒ NB LTE Band12/85:≤11.798dBi
❒ NB LTE Band13:≤12.214dBi
❒ BNLTE Band14:≤12.272 dBi