14
Steam delivery
1. Wait until the heater light switches off (p) and make sure that the
pressure indicated on the boiler gauge (h) is over 0,8 Bar.
2. Open the Steam valve (d) for a few seconds and discharge a little steam
into the drip tray (j), then immerse the steam wand (e) in the brew to be
heated and turn on the tap, when the required temperature is reached, turn
off the tap.
After heating the beverage, always discharge a little steam from
the wand to clean the spray holes.
Hot water delivery
1. Place the container to collect the water under the water wand (g).
2. Turn on the water tap (f) to deliver the hot water.
3. When the required water level is reached, turn off the water tap.
To Next Page
Loading...
Need help?
General
