Quick BTR Series - Page 11

BTR Series
EN
QUICK BTR Series INSTALLATION AND USER’S MANUAL - REV 001C
11
4 - Installation
HULL
COUNTER FLANGE
STRUCTURAL GLUE
GRP LAYERS
GRP LAYERS
GRP LAYERS
GRP LAYERS
• Align the counter ange with the opening of the hull and check that the 4 heights indicated in g.B page 9 are correct.
Apply resin to the counter ange or weld it, in the case of aluminium or steel, according to the techniques identied as the
most suitable for the type of hull construction (g. 5).
HATCH
HULL
COUNTER FLANGE
• On the entire perimeter of the hull opening, make a sturdy stop for closing the hatch (g. 6).
4.2 - Construction and installation of the closing hatch
WARNING: take special care to avoid interference between the cover and the hull opening.
Too precise contacts will cause damage to the entire movement system (g.7).
Fig.7
Fig.8
45°
5 mm
HATCH
COUNTER FLANGE
HINGE SIDE
Quick
®
recommended
laminating system
Fig.6
Fig.5