13
EN
INSTALLATION AND USE MANUAL QUICK MC² X19 REV002A
4 - Safety
4.1 - Warnings
• The stabilizer operates within 200÷240 VAC power supply and LV version 90÷120 VAC
Connect to the electrical line in compliance with the protection standards in force.
The stabilizer motor frame must be properly grounded in order to guarantee the necessary protection in
case of indirect contact.
• While navigating, if the stabilizer rotates at its maximum speed, NOT to disconnect the power supply, in
order to avoid interrupting the gyroscope precession motion control.
• Secure the stabilizer to the boat structure by means of screws/nuts with strength class no less than 10.9.
• For tightening, use a torque wrench with the torque indicated by the manufacturer (see section 7.4 and 7.5)
DUE TO THE EXTREMELY HIGH ROTATION SPEED OF STABILIZERS, INSTALLERS AND USERS MUST STRICTLY
COMPLY WITH THE FOLLOWING WARNINGS:
• Activate the stabilizer only after having installed it correctly.
• Activate the stabilizer with the protection devices inserted
• Do NOT touch the stabilizer while it is running to prevent the danger of getting seriously
injured and damaging the gyroscope.
• Do NOT remove the external cover.
• Do NOT place any object, hands or body near the rotation area.
• Do NOT introduce extraneous objects inside the protection cover.
* Disconnect the stabilizer from the power supply and make sure that the flywheel has
stopped completely before performing any operation (
see info on display RC), such as cleaning or a simple inspection,
in order to prevent any damage to people or objects caused by an accidental start-up.
* Restore the power supply only after having correctly installed all
the safety devices that were removed to carry out the operations.
* Do NOT perform any type of electrical maintenance on any system device while
the stabilizer is disconnected from the power supply and the FLYWHEEL IS STILL ROTATING,
as its force continues to generate current.
* CLEANING THE APPLIANCE
• Do NOT use solvents or fuels to clean the appliance.
• Do NOT remove the safety labels on the equipment.
4.0 - Precautions
• Comply with all the safety warnings included in this manual.
• Comply with all the technical parameters indicated in this manual.
• The stabilizer must be lifted only by means of the lifting straps
properly secured to the supports on the base of the product.
• Handle with care paying attention to avoid damaging the gyro or getting injured.
• Strictly observe all the local accident prevention standards during both
assembling and regular operation.
• The work area shall be large enough to enable technicians
to assemble/disassemble the stabilizer.
• The stabilizer must be installed in a suitably ventilated place.
• Maximum cleanliness must be guaranteed during operations.
• Do not place any objects on the anti-roll stabilizer
• The environment where the stabilizer is installed must be dry and clean (no water, no splashes)
Further details on how to handle the appliance on section 5 of this manual.
*
WARNING: THIS OPERATION MUST BE CARRIED OUT BY QUICK AUTHORIZED
PERSONNEL ONLY. REMOVING THE COVERS AND SEALS WILL
VOID THE QUICK WARRANTY.
To Next Page
Loading...
Need help?
General
