21
EN
INSTALLATION AND USE MANUAL QUICK MC² X19 REV002A
7 - Installation procedures
The installation instructions include all the procedures that are necessary to assemble and fix the stabilizer.
Quick
®
provides all the mechanical and electrical components for the correct operation of the appliance.
7.2 - Warnings
Prevent dust or any type of fragment from accidentally getting inside the gyroscope. Keep the equipment
protected and clean and clean the base very thoroughly before installing it, especially after the preparation
and drilling phases.
• The stabilizer must be installed parallel to the boat's transverse axis.
• IMPORTANT: POSITION THE STABILIZER FOLLOWING THE INDICATIONS OF THE DRILLING TEMPLATE.
THE STICKER ON THE COVER (FLYWHEEL ROTATION) MUST BE POSITIONED TOWARDS THE STERN OR TOWARDS THE BOW.
7.1 - Types of Underbody
• Fiberglass hulls
The fiberglass support shall be laminated to the hull, in compliance with the regulations in force.
Considering the mechanical stress to which the hull will be subjected, extra care should be placed on the lamination. If the
support structure has to be reinforced, we recommend incorporating aluminum or brass plates in the fiberglass.
• Aluminum alloy or steel hulls
The aluminum alloy or steel mounting structure shall be welded to the hull. Consult the manufacturer/boatyard, naval
engineers and/or specialized companies to assess additional modifications such as cross-beams and stringers near the unit
to be installed.
• Wood hull
Consult the manufacturer/boatyard, naval engineers and/or specialized companies to assess suitable additional
modifications.
7.0 - Support structure
The reinforced mounting structure that supports the stabilizer must be designed and built according to the boat
characteristics and should be made by a certified installer or a boatyard.
The mounting structure should be built by qualified personnel only after having conducted a suitable analysis on
the loads that the gyroscope will transfer to the hull (see section 6.0).
Quick
®
SpA will assume no responsibility for the manufacturing of the mounting structure on which the stabilizer is
to be installed.
However, considering a typical installation, it is advisable to refer to the examples that will follow in points 7.4 and 7.5 of this
manual. These examples are to be considered purely indicative.
ROTATING PARTS!
DANGER
ROTATING PARTS!
DANGER
centrato
centrato
ROTATING PARTS!
DANGER
ROTATING PARTS!
DANGER
centrato
centrato
ROTATING PARTS!
DANGER
ROTATING PARTS!
DANGER
centrato
centrato
ROTATING PARTS!
DANGER
ROTATING PARTS!
DANGER
centrato
centrato
BOW
STERN
To Next Page
Loading...
Need help?
General
