Quick MC2 X19 User Manual

35
EN
INSTALLATION AND USE MANUAL QUICK MC² X19 REV002A
10 - Maintenance
10.4 - External Cleaning
Clean the stabilizer with a soft cloth dampened with water; do not use chemicals or abrasives.
Use the torque wrench to tighten the bolts.
Refer to Nm on page 11
SYSTEM / COMPONENT ACTIVITY PERIODIC
MECHANICAL
Replace silent block and precession sensor belt
5 years
Maintenance table (5 years) - only Quick authorized technicians
MC
²
X19
n° 8 screws
base plate
(optional)
C
C
A
B
MC
²
X19
n° 12 screws
with base plate
(optional)
10 - Maintenance
STRICTLY OBSERVE ALL PRECAUTIONS INDICATED IN THE MANUAL IN ORDER NOT TO
DAMAGE YOURSELF AND THE STABILIZER.
IF IN DOUBT, CONTACT YOUR NEAREST “QUICK
®
” DEALER.
10.3 - *Annual Maintenance
SYSTEM / COMPONENT ACTIVITY PERIODIC
MECHANICAL CHECK THE STABILIZER FOR CORROSION OR RUBBING MARKS. (FIGURE A) ANNUAL
ELECTRICAL CHECK THE CONNECTORS FOR CORRECT FIXING AND THE PRESENCE OF OXIDE. ANNUAL
HYDRAULIC REMOVE THE TOP COVER AND CHECK FOR OIL LEAKS. (FIGURE B) ANNUAL
FIXING
CHECK THAT THE SCREWS FIXING THE STABILIZER TO THE HULL ARE TIGHTENED
CORRECTLY (FIGURE C).
THE VALUES ARE INDICATED ON PAGE 11
ANNUAL
There are no indications/warnings via the RC Remote Control.
Refer to the annual maintenance chart below.
Annual maintenance table
* WARNING: THIS OPERATION MUST BE CARRIED OUT BY QUICK
AUTHORIZED PERSONNEL ONLY. REMOVING THE
COVERS AND SEALS WILL VOID THE QUICK WARRANTY.

Quick MC2 X19 Specifications

General

Brand	Quick
Model	MC2 X19
Category	Boating Equipment
Language	English