The Quingo Flyte is transported using the Quingo Docking Station. There is minimal lifting
required to be able to load/ unload the scooter from your car.
The following process shows how to fold your Quingo Flyte, this can be in a confined
storage location or ready to load into your car:-
To ensure the Flyte is folded to a compact position, make sure the seat is in the rear
position (furthest from the tiller)
Remove both Armrests
Remove Front Basket and Centre Basket.
1. Fold the back support down flat.
2. Push the green seat release lever and tilt the front of the seat upwards and over
until the seat unlocks.
3. Now push the seat assembly forwards where it will lower the Flyte’s deck.
4. Release the Tiller locking lever and lower the tiller onto the seat’s velcro fastening.
5. Folding is complete
Note:- Always check the tiller is in the correct folded position for your vehicle when loading.
To Next Page
Loading...
Need help?
General