Additional Information for the Noise reduction wedges.
The Quingo Docking Station is supplied with some noise reduction wedges. You can place
4 off wedges in the docking station, as indicated below, which will reduce the noise when
travelling.
2 off wedges are to be placed at the boot end of the Docking station between the ramps.
2 off wedges are to be placed at the front seat end of the Docking station between the
ramps and carriage section.
Please Note:-
The Noise reduction wedges must be removed before loading and unloading the Flyte
onto the Docking Station to prevent the ramps from becoming stuck and not closing
completely.
All Suction Clamp fittings, Seat Support Clamps & Thumb Screws to be checked daily for
security.
To Next Page
Loading...