14
Important installation notes
The sensor cables (e.g. temperature sensor cable) must be
routed at a distance of at least 50 mm to sources of electro-
magnetic interference (switches, electric motors, uorescent
lamps).
An installed meter is a pressurized component.
Risk of scolds from hot water.
Fitting only by trained experts.
Refer to operating manual, operating conditions and installation
requirements in accordance with EN 1434-6.
Directly immersed installation variant
This variant is always recommended.
Indirectly immersed installation variant
Please note national and country-specic
regulations concerning the use of immersion sleeves.
Heed correct supply ow or return ow installation and the
installation position of the ow sensor.
To Next Page
Loading...
Need help?
General
