1. Connect the hoses
Connect the hot, cold and mixer water
hose to the tap.
2. Tap through the work top
Push the tap through the hole in the work
top.
3. Tighten the threaded ring
Put the tap in the required position and
fully tighten the threaded ring.
4. Secure the screws
Tighten the screws in the threaded ring.
Fitting Flex tap
• When installing the tank it is necessary to take into account that the Flex tap counterweight
must be able to move up and down freely. When the hose is not withdrawn it hangs
approximately 40 cm below the work surface.
• Note: When tting the tap to a thin work top use the white tap support before placing the
metal ring and threaded ring around the hoses.
B
3
1
3
2
4
To Next Page
Loading...
