Cold
Connecting water
• The Quooker system operates under mains water pressure and must always be installed on to
the water pipe with the supplied inlet reducing valve.
• The Nordic single tap, the Fusion tap, or the Flex tap must be installed according to the locally
applicable regulations.
1
3
2
4
1. Connect the inlet reducing valve and
hose
Prior to installation, close the corner
shut-o tap or turn o the water supply to
the main tap. Install the supplied isolation
valve. Connect the inlet reducing valve
to the isolation valve with an inlet hose
screen. Connect the cold water hose with
an inlet hose screen to the inlet reducing
valve.
2. Connect the mixing valve
Use the supplied bre washer to connect
the mixing valve to the inlet reducing
valve. Make sure that the temperature
setting knob of the mixing valve remains
accessible. Use this knob to adjust the hot
water temperature (between 40 °C and
60 °C). Connect the Fusion or Flex mixer
tap hot water hose to the mixing valve
using an inlet hose screen.
3. Install the return hose
Place the tank in position and connect the
return hose of the tank to the mixing valve.
Note: A washer is not required.
4. Install the check valve and inlet hose
Connect the check valve and the inlet
hose of the tank to the mixing valve. Note:
A washer is not required.
C
old
To Next Page
Loading...
