7.3.2.3: Full automatic channel search and storage: In the mode of reception, long
press “ ” for 2 seconds to automatically search and store channels from the lowest
frequency to the highest frequency of current band. The channel search will stop
automatically.
In the process of automatic channel search, “PRESET 01-PRESET **” appears on the
top right of the LCD (the number means the address of storing a channel).
After a round of searches is finished, the search will stop automatically and the
program of the first frequency stored will be played.
199 channels stored in every band. 995 channels in total (except WB).
Warm prompt: the number of channels stored depends on local signal intensity.
7.3.2.4: Shuttle channel search: in the mode of reception, rotate the shuttle knob on the
right of radio “ ” to choose a channel up and down.
Quick shuttle channel search: rotate “ ”, the number behind the frequency
flashes for 2 seconds. When the number is flashing, press “ ” to switch between
numbers flashing. When the number is flashing, rotate “ ” to quickly choose a
channel up and down.
7.3.2.5: “ ” Rotating dial search:
Special description of rotating dial search:
Limited by the chip of this product, VHF/AIR/WB only supports rough frequency
adjustment and doesn’t support accurate manual channel search using the knob, which
means that the step is limited and fine adjustment can only be realized in combination
with TUNE+/TUNE-.
In the mode of FM/MW/SW, channels can be searched manually using the Rotating dial
for searching the accurate channel.
In the mode of FM/SW, when searching channels manually using the Rotating dial,
press “SUB BAND” to switch between receiving frequency ranges.
Turn on the Rotating dial.Slow rotation the [ ]
In the mode of FM, press “SUB BAND” to choose from four receiving band ranges.
FM1:87-108MHZ
FM2:76-108MHZ
RF320
10
To Next Page
Loading...
