7.3.4: Switch between VHF wavelets:
VHF receiving range: 30.00-199.975MHZ
In order to receive a channel more quickly, in the mode of VHF: there are 9 VHF
wavelets. press “ ”, LCD shows: 30.00MHZ, 50.00MHZ, 70.00MHZ, 90.00MHZ,
110.00MHZ, 130.00MHZ, 150.00MHZ, 170.00MHZ, 190.00MHZ. press “ ” to
quickly switch and choose.
7.3.5: Switch between AIR wavelets:
AIR receiving range: 118.00-138.00MHZ. In the mode of AIR: press “ ” , LCD
shows: 118.00MHZ, 123.00MHZ, 128.00MHZ, 133.00MHZ, 138.00MHZ. press
“ ” to quickly switch and choose.
7.3.6: Setting of VHF bandwidth:
In the mode of VHF, long press “ ” for 2 seconds to show current VHF bandwidth
5KHZ. When bandwidth is shown, press “ ” to choose a bandwidth from 50KHZ,
100KHZ, 150KHZ and 200KHZ. After choosing a bandwidth, the radio will exit setting
of bandwidth automatically within 3 seconds and automatically confirm the bandwidth
chosen finally.
Note: the factory default value of VHF-NFM is 5 KHZ.
If 50KHZ, 100KHZ, 150KHZ or 200KHZ is chosen, the radio will receive signals in the
mode of VHF-WFM demodulation.
7.4. Method of memory a station manually
On Radio receive mode, search the target frequency using the methods in 7.3.2. Long
press “ ” for 2 seconds to enter the mode of memory a station manually, the address
of memory station number appears on LCD and “PRESET **” flashes, now press
“ ” or “ ” to choose an address of memory station number .after that,and press
“ ” again for confirm .
7.5. Recall station
Memory stations using the methods in 7.3.2.3 and 7.4.
Press “ ” to enter recall the memory station. When “PRESET **” is displayed, press
“ ” “ ” or rotate the pulley on the right “ ” to choose an address number
of memory station.
Note: “PRESET -- ” means no channel stored.
RF320
12
To Next Page
Loading...
