Radial Engineering PZ-Pre - Output Connections Explained

True to the Music
Radial Engineering Ltd.
PZ-Pre
™
User Guide
180° Polarity Reverse
The POST-EQ XLR balanced output features a polarity reverse
for absolute phase alignment. This recessed switch will invert the
signal polarity of the POST-EQ XLR output by reversing pins-2
and 3 at the XLR connector. The default position for the switch is
pushed out where pin-2 is positive. This is the AES standard for
XLR connectors and is sometimes called 'pin-2 hot'.
8
OUTPUT SECTION
Post-EQ DI Output
This balanced XLR output is another active direct box. It produces
a 600 Ohm, mic-level signal suitable for connecting to mixing
consoles. The POST-EQ XLR OUT comes at the end of the PZ-
Pre signal path after the  lters, equalizer, PHASE, BOOST and
LOOP functions. It is intended to feed a stage monitoring system
or in-ear monitors allowing the player to control their on-stage
tone through the PZ-Pre controls.
XLR OUTS
Polarity Reverse
XLR OUTS
Ground Lift
Dry
Pre-EQ
Wet
Post-EQ
Low-Cut
Filter
Notch
Filter
3-Band
EQ
Power
Boost
Effect
Loop
Dry
Pre-EQ
Out
Input
Wet
Post-EQ
Out
Send Recv
¼" Instrument Amp Output
The ¼” OUTPUT jack connects to the musician’s on-stage
ampli er. This output is at the end of the PZ-Pre signal path and
is affected by all the controls.