Radian 3RX - Harness Setup and Adjustment

Radian® 3RX
26
FIRST SETUP
HARNESS SETUP
1. Place your child in the seat. Make sure their back is at
against the car seat back (this can be done in or out of
the car). Avoid bulky or heavy clothing because they
will prevent the harness straps from being tightened
properly at rst tment.
2. Place harness straps over child’s shoulders and legs and
buckle. You will hear a “click” when buckle tongues are
securely attached. Pull up on each buckle tongue to
make sure it is securely attached.
3. Be sure the harness straps are at the proper height.
Rear-Facing: Harness straps MUST be at or just below the
child’s shoulders. Top of head must be 1.5 in (3.8 cm) below
the top of the car seat shell. Child should not be on top of or
in front of the buckle.
REAR-FACING
REARFACING
Harness at or just below shoulders