Radian 3RX - Changing Harness Position; Harness Position Adjustment Steps

Radian® 3RX
58
CHANGING HARNESS POSITION
1. Loosen the harness straps. Push down on the harness
adjuster while pulling out on the harness straps at the
chest clip. Unbuckle the chest clip. Detach the buckle
tongues from the buckle.
2. Detach harness straps from metal plate on back of seat.
Pull each harness through to the front of the seat. Re-
locate each harness to the correct slot determined, push
through to the back of the seat taking care to keep each
harness strap at. Re-secure the harness straps to the
metal plate. Check to ensure harness loops are properly
secured to the metal plate.
3. Check the buckle position. When rear-facing, the correct
slot is the one that is closest to your child without being
underneath your child. When forward-facing, children
2230 lb (1013.6 kg MUST use the middle buckle
slot only. Children above 30 lb (13.6 kg) MUST use the
forward most buckle slot only.
4. To adjust buckle strap — Remove all lower seat cover
clips from the seat shell. Reach into the rear-facing belt
path. You will feel the buckle strap metal retainer.
5. Rotate metal retainer and insert it up through the shell
and pad. From the top of the car seat, pull the buckle
strap out.