diono.com
57
BOOSTER MODE
BOOSTER MODE INSTALLATION:
WARNING: Make sure the vehicle seat belt can properly
retract before each use.
ALWAYS secure the child restraint using the vehicle belt
or LATCH connectors even when it is unoccupied. It could
injure other occupants in a sudden stop or collision.
NOTE: The 5-Point harness MUST be removed to use this
seat in booster mode.
1. Place child in car seat with their back at against the
back of the seat.
2. Feed the shoulder belt of the vehicle seat belt through
the upper belt guide and over booster seat.
3. Buckle the vehicle lap/shoulder belt. Be sure the
shoulder belt lays across your child’s shoulders,
between the neck and edge of the shoulder. Be sure
the lap portion of the vehicle seat belt goes under
the lower booster belt guide and the belt lays low
across your child’s hips. The shoulder belt should lay
under the lower booster belt guide on the side where
it is buckled.
To Next Page
Loading...
