diono.com
35
REAR–FACING
6. Slide the LATCH/UAS strap
through the rear-facing belt
path and out the other side. The
LATCH strap should lie at and not
be twisted.
7. Attach LATCH/UAS connectors
to vehicle LATCH/UAS anchors
and listen for audible "click" to
conrm engagement.
8. Tighten the LATCH/UAS strap.
Press down rmly in the center of
the car seat while tightening the
LATCH/UAS strap. You may need to
tighten further by pulling upwards
in-line at the belt path as shown.
9. Test for tightness. Grab the seat
at the rear-facing belt path. Try to
move the car seat side-to-side and
front-to-back with the force of a
rm handshake. If the seat moves
less than 1 in (2.5 cm), it is tight
enough. DO NOT test by grasping
the top or back of the car seat.
6
7
8
9
To Next Page
Loading...
